How to register and update WIFI Launch X431 5C/5C PRO

WIFI Launch X431 5C/5C pro, the replacement of Launch X431 V has been carried out for a short time. Following are the installation, register and update instructions of the Launch 5C pro full system automotive diagnostic scanner.

How to install the X431 5C diagnostic connector?
Launch X431 5C Pro install

1) Locate vehicle’s DLC connector. The 16 pin diagnostic connector is generally located on the driver’s side, about 12inches away from the center of the dash board.
2) Plug the 5C diagnostic connector into the OBD-II socket. It is suggested to use OBD-II extension cable to connect the DLC and the connector. If your vehicle is not compatible with 16-pin connector, you need desired connector to communicate.
3) The power indicator of the diagnostic connector will ON when well communication is built.

How to register Launch X431 5C Pro scanner?

Note: Before registering, please charge your X-431 5C diagnostic tool to power on, and set the WIFI wireless connection.

Follow easy 4 steps in the pictures below:
Launch X431 5C Pro Register
Launch X431 5C Pro Register

How to update X431 5C Pro full system software?

After complete register procedure, click “Download” icon to start downloading software.
Launch x431 5c pro update
Note:
Make sure that WIFI connection is strong and stable during the downloading procedure.
All vehicle software have been selected by default. To deselect certain software, just uncheck the box next to the software version.
The software packages will be installed automatically once downloading finished.
Please keep synchronized with the latest version for better service and functions.

Launch X431 5C pro ynchronized

Be the first to comment

Leave a Reply

Your email address will not be published.


*