Error when programming BMW F32 in ISTA-P 4.19.13 Expert Mode (Solved)

April 6, 2020 Eva BMW ICOM 0

Problem:

I had error when programming BMW F32 in ISTA-P 4.19.13 Expert Mode. Vehicle programming with ISTA/P is no longer approved for the connected vehicle. Vehicle management is now only possible with ISTA 4.

The-Way-to-Set-up-BMW-F-I-G-Series-Programming-in-ISTA+1
The-Way-to-Set-up-BMW-F-I-G-Series-Programming-in-ISTA+2

*Before version ISTA 4 it was called ISTA/D (aka Rheingold).
It would cover diagnosis on all cars.
Beginning from version 4 its called ISTA+.

Solution:

The error indicates that  BMW F, I, G series programming is not available in ISTA-P (since version 4.19.xx), but in ISTA+ instead.

From version 4, besides diagnosis it also covers programming of F series.
and ISTA/P is left for programming of E series only (therefore ISTA/P can not program F series anymore).

Here’re tips to set up programming in ISTA+ ( Rheingold or ISTA-D).

Run ISTA+ software, identify vehicle

Then choose Service Plan

The-Way-to-Set-up-BMW-F-I-G-Series-Programming-in-ISTA+3

Choose Programming Plan

The-Way-to-Set-up-BMW-F-I-G-Series-Programming-in-ISTA+4

(CLICK TO ENLARGE IMAGE)

Then Execute measures plan

The-Way-to-Set-up-BMW-F-I-G-Series-Programming-in-ISTA+5

Follow ISTA prompts to carry out programming.

The-Way-to-Set-up-BMW-F-I-G-Series-Programming-in-ISTA+6

How to install BMW ISTA+ for Diagnostic & Programming

Related posts:

  1. HOW TO CONFIGURE EXPERT MODE OF BMW ICOM ISTA-D ISTA-P
  2. How to Enable ISTA+ V4.11 Expert Mode for Single Module Programming
  3. How to solved the problem with ISTA and BMW m3 e36 of 96
  4. How to Solve BMW ISTA+ 4.1 “Programming is not possible”

Be the first to comment

Leave a Reply

Your email address will not be published.


*