Success! Have tested Tech 2 clone for 2009 Chevrolet HHR key fob!
The detail… Here you go.
Install the GM Tech 2 scan tool
Turn ON the ignition with the engine OFF
Power On the Scan Tool
Hit Enter
Main Menu > F0: DIAGNOSTICS
Vehicle identification – Model Year > (9) 2009
Vehicle identification – Product Type > Passenger Car
Vehicle identification – Product Make > (1) Chevrolet
Vehicle identification – Product Line > A
Diagnostics > F1: Body
Body> F5: Remote Control Door Lock Receiver
Module Setup > F1: Program Key Fobs
Program Key Fobs > F0: Invalidate all key fobs
Instructions:
The procedure will replace the previously programmed key fob with the key fob requiring programming.
(Follow Instructions, if it don’t work repeat entire procedure)
All desired key fobs must be present.
When the first key fob is programmed, the module will erase the rest of the slots.
The module will fill slots until [Done] or [Exit] is selected.
Note: Only select [Start] once. If the procedure is started again, the control module will start over.
Job’s done!
Leave a Reply