Year: 2022

How-to-Detect-Ignition-Coil-with-Xhorse-VVDI-Key-Tool-Plus-1

How to Detect Ignition Coil with Xhorse VVDI Key Tool Plus

The Xhorse VVDI Key Tool Plus Pad can detect the ignition coil to confirm whether the vehicle is equipped with chip and immo system when all the keys are lost. How to recognize vehicle ignition coil for AKL? 1. Place the VVDI Key Tool Plus coil near the ignition, go to:

How-to-Connect-JLR-DoIP-VCI-Pathfinder-Interface

How to Connect JLR DoIP VCI Pathfinder Interface

The new JLR approved DOIP VCI is the only unit that will be compatible with Pathfinder and all JLR vehicles with the new vehicle architectures (from the Range Rover/Range Rover Sport (L405/L494) 17MY onwards) or allow the enhanced diagnostics that Pathfinder will offer the retailer. Part 1: How to Connect

Ktag-or-PCMTuner-Read-Ford-SID807EVO-which-is-better-1

Ktag or PCMTuner Read Ford SID807EVO, which is better?

Question: I need to read and write Ford Connect 2014 Continental SID 807evo ecu. Tried with KTAG 6.070 China clone, no luck. It reads it up to 52% at the ktag and then puts me an error. Then i tried the new PCMtuner. It failed me again. Any solution? Solution: Ktag:

How-to-Use-Launch-X431-PRO5-Perform-DSG-Transmission-Basic-Setting-for-VW-Passat-1

How to Use Launch X431 PRO5 Perform “DSG Transmission Basic Setting” for VW Passat

Today we’d like to say Launch X431 PRO5 can do DSG Transmission Basic Setting for VW Passat , it’s also applied to Launch X431 PAD V, X431 Pro3 V4.0, X431 Pad VII etc. When you repair your 2013 VW Passat , after you change DSG Transmission, DSG clutch pack, DSG mechatronic, DTC

How to Read and Write VAG DQ200 DQ250 with PCMTuner

Question: I cannot read VAG DQ200 grearbox TCU with PCMtuner. Why do I have grey buttons on read and write Have the Same Problem with DQ250. Solution: If you are reading through obd you can only VR read, need to id and request file. If you read on bench you

How-to-solve-benz-c6-installation-file-check-failure-1

How to solve benz c6 installation file check failure

When installing MB Star C6 driver for 2021/12 xentry software, this prompt appears:‘The file checked failed, try again’,‘Connect device error, ping failed’. When I Delete and reinstall the C6 driver, another RunCommand Error popped up. How to solve? Solution: Customer got technical support from Obd2tool.com engineer via Teamviewer. Change another good network