USB-Link 2 Bluetooth Edition Installation and Setup Manual

XTruck-2 USB Link + Software Diesel Truck Interface And Software With All Installers

IDSC Holdings LLC retains all ownership rights to USB-Link 2 and its documentation. The NEXIQ USB Link 2 source code is a confidential trade secret of IDSC Holdings LLC. You may not decipher or de-co npile USB-Link 2, develop source code for USB-Link 2: or knowingly allow others to do so. The USB-Link 2 and its documentation may not be sublicensed or transferred without the prior written consent of IDSC Holdings LLC.

This manual as well as the software it describes, is furnished under license and may only be used or copied in accordance with the terms of such license. The content of this manual is furnished for informational use only: is subject to change without notice, and should not be construed as a commitn^nt by IDSC Holdings LLC. IDSC Holdings LLC assumes no responsibility or liability for any errors or inaccuracies that may appear in this book.

Except as permitted by such license, no part of this publication maybe reproduced: or transmitted, in any form or by any means: electronic, mechanical: or otherwise, without the prior written permission of IDSC Holdings LLC.

Tech-2 for GM is the same tester GM Technicians use to diagnose GM vehicles.It is an excellent tester for technicians to diagnose GM vehicles.An industry change in protocol from obd2 scanner to Controller Area Network (CAN) has begun.

In order to perform diagnostics on a vehicle that uses the CAN interface; you will need the GM Tech2 Flash and a CAN diagnostic interface module. The module connects between the Tech 2 Flashs diagnostic link cable and the OBD adapter. Once the module is connected, it can be used on all GM vehicle applications,even those vehicles using other platforms such as OBD I and OBD II.

Be the first to comment

Leave a Reply

Your email address will not be published.


*